Attention:This product must be used with a gateway and there must have a neutral line.
Product Size: 49.3*46*24mm
Wireless Connections: Zigbee
Input Voltage: 100-250V, 50Hz
Operating Temperature: -10℃~+50℃
Wireless Relay Controller (2 Channels) Wiring Guide
Standardize the wiring operations of the power supply part of Wireless Relay Controller (2 Channels)
Wireless Relay Controller (2 Channels)
3.Scope of Application Operations of client side
Operations of client side
Prepare items and environment: one Aqara Wireless Relay Controller (2 Channels), one power cord, and one Phillips screwdriver.
5.Wiring Operation Process
Note: Connect one end of the red jumper wire to L and the other end to IN. The screws must be tightened. After tightening them, you can try pulling the cable to check whether it is fixed.Remarks: The other end of the jumper wire can connect to one of the two IN ports, except for the connection method shown in the above picture.
5.2Power Code Wiring
Note: Connect the live wire of the power cord to the IN port and the neutral wire to the N port.Remark: The power supply part should connect to these 4 ports, and you can power on the device after the wiring is completed.
Note: 1. Connect the power cord directly without the red jumper wire;2. One end of the jumper wire is connected but the other end of the jumper wire is not connected, or the screws are not tightened.The above conditions will cause instantaneous damage to Aqara Wireless Relay Controller (2 Channels).